Originally Posted by
Hobbymasters
Help! At the track now with Tekno sc, tekin pro 4600, rx8, and 2s 5800mah 70c. The positive lead keeps heating and unsoldering on 2 minutes of running. ESC is 108, motor is 100 degrees. Tried the current limiter from one end to the other end of the spectrum. Gear mesh is good and drivetrain rolls smooth. Any ideas?
What kind of connector? Bullet? Its tired and squished in on itself. Replace with fresh bullets.
Deans or other plug together? Clean the tabs and stuff with alcohol if possible, those can get dirty and not make good contact... or replace.