R/C Tech Forums - View Single Post - Team Associated B4.2 Thread
Thread: Team Associated B4.2 Thread
View Single Post
Old 08-16-2013 | 07:27 AM
  #8235  
YankeeFan123's Avatar
YankeeFan123
Tech Elite
iTrader: (73)
 
Joined: Jun 2010
Posts: 3,218
From: San Diego, California
Default
Originally Posted by Grasschopper
Ok so I've been going over my B4 and setting everything to the factory specs. The result of this is -2 deg camber in the back and....-5 deg in the front. I measured the camber links several times and am in the kit hole (inside at the tower with 2 washers and hole A at the caster block). Why do I have so much negative camber in the front using the factory setup?
-5? I run -1 deg, or did you mean -.5?
YankeeFan123 is offline  
Reply