Originally Posted by
Waflet
Hideeho
I use black grease (always have tons more of that than anything else laying around) & a drill to install my cups for the 1st time.I put the grease on the threads, the cup in the drill chuck & drill it on & back off. Then I clean it up & put the cup on manually to where it needs to be.
I use the drill as well. Just be sure to go very slow so you dont build up too much heat or they will be impossible to adjust. Also add some grease to the threads of the turnbuckle. Just installed them on all 3 of my kits yesterday with Fin turnbuckles and had no issues at all. B4.2,B44.2,T4.2
