R/C Tech Forums - View Single Post - OFNA GT-V2e 1/8 GT
View Single Post
Old 08-03-2013, 11:00 AM
  #335  
Jstall7543
Tech Elite
iTrader: (2)
 
Jstall7543's Avatar
 
Join Date: Jul 2009
Location: Down Town Olympia
Posts: 3,106
Trader Rating: 2 (100%+)
Default

Originally Posted by ckhaber
You mean turn as in lathe work.The spindle shaft is 8mm, Kershaw pinion is 8mm,should slide right on, no?
Ya, it slides right on but its about .05 to .075 to thick on the set screw side so when I slide it on flush till it hits the stop my diff risers are to far apart to get the holes to line up in the chassis and top plate. Looking like I will need to turn it.
Jstall7543 is offline