Originally Posted by
Cain
have you checked the pins for any wear?
Originally Posted by
MantisWorx
Sounds like the spring has had it, you need the Hd spring. I think Cam was the only one who pinned one and he was on on high bite. You dont need to pin it though, make sure everything is clean and dry, replace the spring and you should be good to go.
Good call on the pins Cain, the latest pins are much more durable than the first ones but eventually will wear.
Pins are new, one run in, and the spring is new. Not sure which one it is, its silver-ish looking.
It doesnt seem to slip, under finger pressure, will check it again. The truck was good, the track had good traction but not like being on clay. I will install 8 pins, and see how it drives.
I'll sand the back side of washers as well, make sure there seating against the slipper plates.
Do i assemble it all dry, or AE diff grease on the pins and balls?
Thanks, Krom.