Originally Posted by
MonsterSummit
Just for clarification, you are running the inside ball down, but how are you running the outer ball at the wheel. Up or down with the additional shim?
The outer ball always has to be run ball up so this is how we left it but placed an additional 2mm metal washer under it. We used the ones from the 22 line and just held them with pliers as we drove the screw through it, lol.
Originally Posted by
Sivaaji
Ryan, Thanks for all the tips. I noticed you are running the same ESC/motor combo as I have coming so please give me your latest settings for your RX8 that runs the Pro4HD 4300? Thanks
I am running my motor pretty hard but it is known I apparently don't pull as hard as most as I can run an identical car as others and come off a little cooler, so just putting that out there...lol. Always check temps during your test runs.
I am geared 16/39 with the pro4 hd 4300.
timing - 35
finish - type in 17500
start - of the options, choose the one in the 3000 range
current limit - 75 (I played with this a lot, more than 75 with this motor produces wheel spin and lower lap times)
brakes - 100 in esc, 37 on radio
minimum throttle - 1
I think those are the important ones...