Originally Posted by
Brett.w
Hi All
Could somebody please tell me where I can find reference on the numbered suspension bracket inserts. I am trying to find out how much toe in I have on the rear using block number 5.
This is the 2.0 version if that matters
Thanks
Brett
Im assuming youre talking about the 'd' plate (rear most plate). With the holes on the inserts towards the outside, you will have 3.5 degrees of rear toe. putting the holes towards the inside gives you 2.5
Originally Posted by
mrnizzles
^ LOL good luck with that one!! I've been looking for that 4-eva! The only thing I have is a chart that show what values you get when their up or down, but not cross-referenced to the actual 'number' printed on the plastic insert itself to get those values, eghh, soooOO frustrating.
I figure it's not going to help my bad driving, so I just put in whatever so long as their equal left/right... huh, maybe thats why I'm always trying to tune 'out' steering response :smack:
http://www.serpent.com/product/600008/downloads/
