View Single Post
Old 07-01-2013, 02:27 AM
 
Drift_Buggy
Tech Elite
iTrader: (22)
 
Drift_Buggy's Avatar
 
Join Date: Dec 2004
Location: Australia
Posts: 2,661
Trader Rating: 22 (100%+)
Default

Originally Posted by eper View Post
you could run a shim there but the only time i thought i had to i ended up havind a bad carrier bearing on the output shaft of the diff. i would recomend going through both those first. my bearing looked and worked fine but if you put a side load on the inner race it would slide over about 3mm and then the diff would be able to move side to side. so be sure to really go through them
Thanks for the reply, hopefully tomorrow I will get a chance to quick over the whole assembly.
Drift_Buggy is offline  
Reply With Quote