Originally Posted by
Rockthecatbox21
Somebody requested i post pics of my xerun 150 amp & 2250Kv setup in my eb48. It was a tight fit, but it hasn't had any problems in the past 4 months i've raced this buggy.
If you zoom in on top picture you can see the motor mount failer (I was talking about in the truggy et48 forum) starting. Where the bottom flange is starting to bend. It also looks like your motor is starting to twist toward the center too.
Not near as bad as mine have been (on my 3rd front diff carrier) but I am using a 1900 with large pinion (18-19) so the motor is toward the edge of the diff carrier. Not the end if the world but it could used beefed up.