R/C Tech Forums - View Single Post - Tekno SCT410 Thread
View Single Post
Old 06-26-2013 | 11:35 AM
  #11536  
GrimmReaper's Avatar
GrimmReaper
Tech Apprentice
 
Joined: Feb 2013
Posts: 73
From: West Des Moines, Iowa
Default

Originally Posted by Cain
For the Matt Wolter setup, the most recent one using the Tekno 1.4 x 8 hole pistons, how do they compare to say the Kyosho 1.3 x hole's ?
The Kyosho 1.3's were good, but when I went to the Tekno 8 X 1.4's the truck has great pack (Bench test, 12"-16" drop, and no chassis slap), but was also good in the whoop section. My truck has never felt so dialed. I also put the 2.6mm rear sway bar, and 2.4mm front sway bar in as well.

Last night I ran times at my local track that were better that most of the 8th scales. Granted, it's a small indoor track with a 10 sec lap times being very good. I've only seen a couple of 9.9's, which were all EB48's, but I was turning 10.3's with the SCT last night on Matt Wolters setup. I did use Hot Bodies Beams with AKA foams though. I really felt good about the truck for the first time.
GrimmReaper is offline