Originally Posted by
Bob Malphurs
LOL....Sometimes more opinions than answers!
Yes...if loop worked with your old AMB it will work with your new MyLaps RC4 decoder.
From the AMBrc manual:
"Any wire similar to the AMB wire is suitable. Install a resistor of 470 Ohm (0.15 - 0.5 watt) opposite to the connection box."
Thanks Bob! I was sweating for a minute....Would have sucked to have a new toy and not be able to use it at the last minute....
Originally Posted by
Bob Malphurs
I have used 18ga wire without the resistor on wider tracks.
Nice to know that too....
