On the vtx 10r 7.5 motor where is o degree timing it starts at 15 goes to 45 if i keep turning right past the 15 till it stops is that 0 degree's my stuff is always running warmer than i think it should,out of the box it was setup on 30 degree's never once thought about checking it on first run till i smelt bandaids,feel like it should have been set lower from manufacturer to avoid the death of the motor on first run just a little food for thought for the engineers who decided to shipp out that way,i know of many others this has happened to also. So for everyone thats gonna say you should have checked that before running the motor,make that statement in manual and it might not happen