R/C Tech Forums - View Single Post - The Speed Passion Thread
Thread: The Speed Passion Thread
View Single Post
Old 06-06-2013, 09:16 PM
  #11637  
Nanoframe
Tech Regular
iTrader: (1)
 
Nanoframe's Avatar
 
Join Date: Feb 2004
Location: Line Ark
Posts: 325
Trader Rating: 1 (100%+)
Default
Originally Posted by chevtech23
Brand new Reventon R, LED card, installed software from the site, PC does not see the card. If i hold the "value" button on while i power up it says "PC" on the card but nothing else happens. If I try and just use the card hooked up to the ESC, after it powers up i just get a "--" on the screen and none of the buttons do anything. Not impressed so far... Any tips?
Try a different USB cable, I had the same problem until I tried a different cable I had lying around. Apparently the UsB cable that came with the ESC can only supply power and not data. I could be wrong about this but it worked flawlessly after I changed it.

Hope this helps!
Nanoframe is offline  
Reply