Has anyone tried the 4-wheel steering mixes?... I find that with two independent steering servos on channel 1 (front) and channel 3 (rear) the programming needs some work...
Mode "same phase" and "Reverse phase" work as expected - however, "Front side" mode causes Ch1 to "Steer" but Ch3 does not CENTER - it moves all the way to one end of travel, so the rear wheels are "locked" at FULL THROW... Also, "Rear Side" does NOT cause the expected centering of CH1 and response of CH3 to the steering wheel - but rather just behaves identically to "Front Side" - with the picture showing that CH1 is expected to be physically plugged into the rear axle steering servo... but I would have expected CH3 to be doing the rear steering throughout... anyone else tried this...?