Originally Posted by
symmetricon
The electronics issue is clearly not relatec to a car specific thread. First thing I would check is to see if the rx is HV compatible sine you have an hv sero. Secondly, did you install the bec correctly i.e, removing the red wire from the esc to rx connection? (correct me if im wrong with this guys)
As far as shock, setup is car specific. I wouod lookup the Mugen MBX6E manual for a base setup and work from there....
Good luck.
I did follow the instructions (pulling the red wire from the esc to the rx) I will check into the rx being HV compatible as i did not know it had to be. Just assumed all rx's were compatible i guess. Bear with me i'm new to r/c since brushless/lipo's and such have come out
Edit- i checked to see if it was compatible for HV. Found it says its Voltage Range is 3.5-9.6V so i assume that it is (correct me if i'm wrong)