Originally Posted by
Team Grid RC
Proper location of the tape for the Lipo will float it, but using in on the front and rear will float the Lipo but not allow the chassis to flex. The Lipo to keep all of its weight on the chassis at all times preventing it from flexing.
The front and rear tape should be half the width of the Lipo, and the center strip to be the full width to support the Lipo and the flexing is at the front and back of the Lipo.
http://www.rctech.net/forum/11071986-post29.html
The two servo mounts will prevent the area underneath the servo from flexing naturally as well. Either get a floating servo mount or remove one of the mounts and use black servo tape under the servo so it will allow the chassis below it to flex.
Originally Posted by
95lscoupe
Loosen up all of the screws for the bulk heads give the chassis a few twists with a bit of force but not a super man twist and tighten the bulkhead screws up in a criss cross patten.
Then to remove tweak take your wheels off and put the car chassis flat on your setup board and loosen up all of your top deck screws and have somebody push down on the shock towers while you tighten your top deck screws in a criss cross pattern. Ive had my 6.1 tweak many times and stray under throttle and this has cured it every time.
Thanks for the help!! I will be getting it back together and see how it runs.