Originally Posted by liljohn1064

I measured my front and rear as assembled just for giggles.

185mm rear with no washers or spacers. Front was 186mm with 2* negative camber measured at the top of tire.

The Front was 196 with 2* negative camber measured at the very bottom of the tire.

The car is approximately 190mm up front with 0* camber.

I'd rather put a 2mm spacer on the diff side axle, a customer length spacer on the other and a clamp hub to get to the right width. Messing with shims inside the wheel just doesn't suit me. Else I will narrow the front to 185 mm as I don't know if the camber adjustment will make the car illegal width. I'm not going to run it @ 0* camber.