Originally Posted by
Mugen10
What base setup did you use? Did you follow a factory driver setup or the basic Xray setup?
I started with the the kit set up but found the car to be too stable. I needed more rotation through the corners. So I installed the 2.5 springs in the rear. 1.5 degrees camber front and rear. Zero shims under the inner front camber link with 2mm under the outside front link. 1 mm under the inner rear camber link and 4 mm under the outside rear link. Kit wheel base. Droop is 6mm front and 5 mm rear. Kit track width.
Note: traction was super high.