Originally Posted by
Integra
Some Servo's Unfortunately aren't as Easy as it Sounds. Some need the Bottom Board to be removed to access the Solder joints and At that Point Most Close the servo up and Go on to the Wires.....Also You do need a Somewhat "Fine" tip to be doing that kind of Soldering work. So for Soldering Newbie's Id much rather see them go the way of the wire.
I have a Hitec 7940TH that I shortened the wire and damaged the insulation and now the wire is too short. The bottom board needs to be removed to replace the wire. I'm not the best at soldering so I'd rather someone else do this. Is there anyplace I can send the servo and have the wires replaced to a custom length? Thanks