+1 on checking out the
www.teamtekin.com homepage for recommended esc setups. I've used the following on a large open asphalt track with a 120' straight. Recommend making adjustments to Boost, Turbo, and End RPM (possibly lowering Turbo and End RPM a few thousand) to meet your track conditions if using on a smaller track. Software: v223, FDR: 6.6, Endbell timing: 0*, Current limiter: 95, Throttle Prof: 3, Boost: 45, Turbo: 10, Turbo Delay: 0.16, Start RPM: 3095, End RPM: 17,993, Ramp rate: 2.0 Not familiar with your motor, but it should be able to run quickly. I preffer Murfdogg Synergy Motors, especially in boosted applications. Hope this helps get you close and periodically check temps (1-2 min) during your first test run trying new setups so you don't overheat your electronics.