Thread: Lab C-02
View Single Post
Old 04-25-2013, 09:15 AM
  #208  
DS Motorsport
Tech Master
iTrader: (2)
 
DS Motorsport's Avatar
 
Join Date: Aug 2005
Location: The Netherlands
Posts: 1,446
Trader Rating: 2 (100%+)
Default

Originally Posted by MrHistory View Post
So i installed my motor with clutch and two speed all box stock and was trying to set the gear mesh.

The outer gear mesh is very tight and the inner gear mesh has a lot of slop. Looking at the motor mount screws under the chassis the motor is correctly squared up, meaning the motor is 90 degree perpendicular to two speed. In order to have a good mesh for both 1st & 2nd gear I would have to mount the motor at a slight angle. Whats up?
It depends on which gears you're using. It's only possible to align the gears perfectly straight when the total amount of teeth are the same for both gearsets.
So for example a 52/15 and 47/20 gearing adds up to a total of 67 teeth on both gearsets. This allows you to align the gears perfectly straight. When both gearsets don't have the same amount of total teeth it's impossible to align the gears straight. When this is the case I would recommend setting the first gear mesh the best you can. The second gear mesh is less important, since it wears a lot less.
DS Motorsport is offline  
Reply With Quote