Thread: Lab C-02
View Single Post
Old 04-24-2013, 04:12 PM
  #201  
MrHistory
Tech Addict
iTrader: (2)
 
MrHistory's Avatar
 
Join Date: May 2011
Location: New York
Posts: 597
Trader Rating: 2 (100%+)
Default

So i installed my motor with clutch and two speed all box stock and was trying to set the gear mesh.

The outer gear mesh is very tight and the inner gear mesh has a lot of slop. Looking at the motor mount screws under the chassis the motor is correctly squared up, meaning the motor is 90 degree perpendicular to two speed. In order to have a good mesh for both 1st & 2nd gear I would have to mount the motor at a slight angle. Whats up?
MrHistory is offline  
Reply With Quote