R/C Tech Forums - View Single Post - Tekno RC EB48 Thread
Thread: Tekno RC EB48 Thread
View Single Post
Old 04-23-2013 | 08:13 PM
  #5926  
justpoet's Avatar
justpoet
Tech Elite
iTrader: (16)
 
Joined: Jan 2012
Posts: 2,063
From: NH, USA
Default
Originally Posted by Dan
Quick question... Planning to run 1900kv on 4S at Norcal Hobbies. What pinion gear tooth should I get. 17T? 18T?
18t, no timing, adjust from there. Using an RX8/T8 1900 (and no current limit), I come off around 120-130 on the ESC with no fan, and 130-135 on the motor with no extra heat sync, pack after pack. I just put a couple holes in the obvious front facing spots on the body to push air in for cooling, and on the back side to let it out.
justpoet is offline  
Reply