Originally Posted by
waymon hamilton
I recently purchased a serpent nitro buggy and converted it using the RC monster conversion...was wondering if anyone knew what bodies I would have to choose from that will clear a four cell hard case battery.
Any help would be greatly appreciated.
I have a Bitty Designs body on mine. I did have to clearance it a bit for the corner of a 4 cell, of if I stagger the 2 2cells backwards, I do not have to (outside battery is shifted to the back of the car).
Originally Posted by
w_dupree
Has anyone noticed the whole servo mount/radio tray flexes when turning under load? Mine flexes a lot , if I hold the wheels and turn the tray flexes quite a bit. If anyone has fixed that what did you do? Yes the three screws hold it in are tight. Endpoints are correct.
Thanks.
Using a KO RSX Power I do not get much flex now that my EPA is set correctly. Are you possibly getting any rubbing from the servo horn? Other thing to check is that the ackerman bar screws are not too tight and binding. I did that once and the servo was fighting against that. Remove the linkage and make sure the steering is free left to right without the servo in the mix.