R/C Tech Forums - View Single Post - TLR TEN-SCTE 2.0 Kit Thread
Thread: TLR TEN-SCTE 2.0 Kit Thread
View Single Post
Old 04-21-2013, 06:51 PM
  #3464  
TCCustoms
Tech Master
iTrader: (9)
 
TCCustoms's Avatar
 
Join Date: Oct 2011
Location: South Central Michigan
Posts: 1,512
Trader Rating: 9 (100%+)
Default
Originally Posted by rifraf
Hello Everyone..I got rid of my Heckno.lol..I purchased a used losi 2.0 roller that has only 2- 5 min of runtime.I would like to know how long of sensor wire I need for a Tekin 550 motor?I am gonna mount my RX8 with the soulder post inside next to the front driveshaft..

Also,Do the tie rod ends cut mark go to the outside of the truck?

Thanks,
275 is about the right length just to give alittle slack in the wire

and i beleive the marks are suppose to be facing the same side...so if your looking at the front of the truck...all the marks should be on either the right or left. I beleive if looking from the front of the truck and the rear is in the distance mine are on the right but if like a normal truck mine are facing the driver side, lol
TCCustoms is offline  
Reply