Center shaft flex on TC
Has anyone had problems with the center shaft being too much out of balance? I usually run 2s and never did a mid air pull but did so after noticing the issue with a 3s, and it flexes at full throttle on 2s as well. The shaft bends around half a mm each way off center on 3s half throttle holding the car mid air (wasn't brave/dumb enough to try full throttle) and the car hasn't been abused, just normal racing on 2s and hasn't seen any rolls or wrecks just the normal bumping, trading paint, etc. I'm wondering if the flex subsides when the drivetrain is under load or if I should be worried about it blowing up or flying out if I try to run a 3s for kicks.
The car in question is an Ofna JL10e. I've already posted in the dedicated thread but I figure anyone with a shaft driven TC could help.