Originally Posted by
IIGQ4U
Installing the Speed Passion program itself is pretty simple, unzip the program, install the USB driver, locate the driver in com ports and double click or right click? to assign it properly and complete the driver installation.
I'm running windows XP on a mac using Parallels.
've been able to successfully load the PC program and my Parallels XP system sees the reventon LCD box as the "CP2102 USB to UART BRIDGE CONTROLLER" but the PC program does not seem to recognize it.
Within the PC folder I do see the "SPusbdriver 6.6" folder. I think I have installed that correctly because now if I click on the setup icon in that folder, it says that the driver is already installed. However, if I unplug and then plug in the LCD box, it get a "new hardware"wizard that pops up.
I'm not sure about this "com ports assignment" you mentioned. Maybe that's what I'm missing.
---
edit: found the device manager and located the reventon box and the device properties says that the device is not configured correctly. So, maybe the USB driver was not installed correctly. So, now I don't know where to go.