Originally Posted by
JiuHaWong
Some things I'd like to see:
- Narrow Aluminum chassis, with a tunnels for servo/esc wire.
- Adjustable Battery holders (ala RB6) so that you don't have to use foam to hold into a shorty.
- I don't mind a RM/MM convertible chassis, but would rather see two purpose built kits (maybe a US version and a Euro version).
- Metric screws
- Teflon shock bushings
- Ceramic Thrust balls
- Ceramic diff balls (cause WildCherry says their better).
- Wing mount that use screws
- Adjustable kickup
- Vertical ball studs for camber links (I know some will disagree, but I like the finer adjustments you can get with the ballstuds in a vertical position)
- Delrin upper shock bushings
- Rear toe mounts in aluminum with teflon inserts (see SpecR R1 design).
In other words, I'm not asking for a lot.
love your suggestions....
Most of all......... Metric hardware!
would like to see alum chassis that has more 'centered' electronics philosophy.
revised suspension parts built around the 12mm shocks (nothing drastic, just make things fit properly with out grinding or rubbing)
redesigned rear hubs, maybe even in plastic, that don't wear as bad as current ones,
no more battery foam (seems petty, but adjustable brace is just a better solution)
I like the idea of adjusting the rear toe with blocks on the back of the hingepins rather the front...just allows for quicker changes.
Arms that support flex tuning plates for high bite surfaces.