Looking for help on fitment sizing.
I have an RC10T4.1 which just broke the ball and cup for the rear. When this happened I lost the dogbone due to how much crap was on the ground and unable to locate it.
I am going to buy and replace, but I was wondering if anyone knew if the fitment would work for what I'm looking into.
Here are the specs I found on the stock driveshaft/dogbone
This is a steel Dogbone (also called a Drive Shaft) from Team Associated.
This is a Stock part for:
RC10 GT
RC10 T4
RC10 T4.1
SC10 2wd
Includes:
One (1) Dogbone
Specifications:
Length: 3.5"(89.78mm)
Diameter: 0.126"(3.2mm)
I am looking at one of these. Not sure on the Diameter though. Cant find it.
HSP RC Car Part Front/Rear Dogbone 89.5mm
Item No: 08029
Anyone able to help on the fitment?