Iam not positive but i think price was $180.
only reason i think it could be hurt was it got up to 310 before i noticed it laying over and fattened it ,
it did idle after the race and never flamed during pits so maybe its ok , there is no noticable pinch in motor, even with plug in it rolls over pretty easy by finger tip,

let me say again for others only reading this post , the damage is my fault due to over heating .

if there any mods to help top end on a large track Dennis PM me with details (i.e open crank bore , more timing, maybe knife edge and a larger flute)

thanks i think the motor is well worth the money, and on any small to mid size track can compete with just about anything ,
p.s. bottom end is very good on this motor.