Hi Mr4,v

Answers to some of your questions:-

1. 10.42, I'd say this software was around a year old (Ish) Current version is 10.72.

2. It looks like the charge / dishacrge current may be incorrectly calibrated or there may be a fault with the discharge FET.

3. I would reccomend you set the voltage cut off to 6v (one volt per cell) this will ensure that when the remote leads are not connected cells will not be reverse charged.

4. If you look on the underside of the charger there is a serial number engraved into the bottom of the charger, PM me with this number, i may be able to find out what the original version is. Also look at the DIN socket that you plug the remot leads into. If it is a 7 pin DIN socket, this will tell you that it is not a really old unit.

Your last question. It is possible that these numbers are the Peak fall back rather than final fall back and may not reflect the actual fallback at the time. If this is not the case then it is difficult to say without checking it out.

Chris.