Originally Posted by
Matt Trimmings
I believe he is referring to raising the inner / lower arm mount, something that is done with tc's often. This is not done as, like raz suggested, there is a plethora of roll center adjustments to be made via hub towers and ball stud washers. And no AE doesn't make different thicknesses of upper decks.
Thank you.
Yes I understand adjusting roll center isn't a reflection of adjusting ride height. As I think you were referring to. My question is to has anyone used any adjustments to the front or do you just rely on the inner portion of the camber link? Has anyone made or tried a front roll bar?
Also still question of an aftermarket "A" or "B" rear carrier piece to adjust the roll center.
So let flaming begin. I typically run on-road the last time I ran off-road was around 98-99.