View Single Post
Old 03-23-2013, 02:24 PM   #5834
MikeXray
Tech Champion
 
MikeXray's Avatar
 
Join Date: Oct 2006
Location: New York
Posts: 5,749
Trader Rating: 73 (100%+)
Default

Ok, so someone was saying the avid/VTS combo fits, what backing plate are you using? the one from my B4 spaces it so far out, there is no way you can thread the nut/spring combo on. I could just dremel off the lip, but I'm curious if there is another plate that is being used. I ended up using the standard b4 setup for now.

I only changed a few things, played with battery forward/back and rear hubs fwd/back (after going back to the stock 0's). Car was still really good, there is only one section of the track I could use some more on power steering on, the rest just getting the right line/timing. I settled on battery fwd (technically this is the middle setting) and hubs back.
__________________
Mike L. Awesomatixusa.com | TQWire.com | Islandraceway.com |JacksonRCracing.com | Horsham RC | Sweepracingusa.com
MikeXray is offline   Reply With Quote