has anyone else bent lunsford hinge pins , when i snapped a arm the other day the hinge pin was difficult to get out... the inner front arm hinge pin is slightly bent i have the revolution design alum front suspension block and it bent at the rear part of the arm did I maybe get a bad set of pins or is this normal? ,, i can see the bend by looking down it or rolling on a flat surface but its still straight enough not to bind at all
edit what foams blocks fit good in the battery tray? right now im using a cut up old dremel case foam
I had the lunsford titanium hingepin kit. and also bent several hingpins. I did not crash or broke a-arms. they just bend.
they are no better then the stock durango hingepins