Originally Posted by Adam-sweety

Hi Guys, I ran my motor (P5xlt) yesterday and only managed a 3/4 lap and motor died. On investigation, the tank was empty and chassis flooded with fuel. Thought hole in the tank, stripped and tank but it was fine, went out again, same issue. Tune was horrible. I then noticed the low speed needle had worked it`s way completely out and only in place by a thread or so. Fuel was running down the side of the motor. Issue I have now is even if i screw it back in, it is not secure enough and worried it will work free again. Any ideas what to do to secure the low speed. Do I need to replace the o-rings. Motor only 4 months old now. Added some green slime which helped but that was a temporary solution.