R/C Tech Forums - View Single Post - HOBBYWING MOTOR TAB ISSUES?
Thread: HOBBYWING MOTOR TAB ISSUES?
View Single Post
Old 03-19-2013 | 12:23 PM
  #4  
cdwilliams1's Avatar
cdwilliams1
Tech Master
iTrader: (38)
 
Joined: Jun 2011
Posts: 1,056
From: Central MN
Default
Originally Posted by Shiloh
The HobbyWing motor posts are just soldered in. Heat them up and remove the posts from the motor tab. Then stick the motor wires through the holes and solder the wires into place. That is how I always run HobbyWing motors. I don't use their solder posts on the motor.
I second that. I do exactly the same thing on my Hobbywing Xerun 17.5
cdwilliams1 is offline  
Reply