Originally Posted by
Acecom1
hey guys so after what, 2-3 days now i have read my manual, followed the break-in instructions and tune instructions on this website. Have spent hours on the net researching and am still at a loss. I have a brand new onfa nexx8t and the damned thing will not hold a tune. i think.(im noob so im not sure)
so on my last post you all helped me with the first few problems i had with the remote binding and throttle trim which fixed the WOT on start up THANK YOU ALL! now that all of that is taken care of.
i am able to adjust the needle settings, well kinda. i have adjusted the high-speed needle and low-speed needle but no matter what i do with the idle needle it wont run at a normal idle. i run it back and forth for about 3-5 mins stop it let it idle. The idle will drop a little at a stand still then ill try to adjust it down more to a more calm idle then it just dies, and wont start again unless i screw the idle needle in a ton. then it will start again and have a stupidly high idle again naturally cuz i screwed the damn screw in just to get it to start again. and this goes on all day with no light at the end of the tunnnle. needless to say im extremely frustrated with the car at this point and am unsure of what to do.
Any suggestions, thoughts, concerns, hypothesis?

Your lsn is rich. It's flooding out at idle. Turn it clockwise an hour or two at a time till it will hold an idle. Once your engine is broke in you'll want to set your idle gap at around .5mm to .7mm and them adjust your idle speed with your lsn and don't touch idle screw again. But, that is after it's broke in.