Originally Posted by
Purdue Engineer
So I just finished the build. Well, I have to do my shocks yet with the 2x 55 pistons. I was thinking: How are you guys check and measure the front toe on the truck without a huddy setup rig?
Also, whats the deal with the front sway bar? It's almost like it's to short. I can't get the end of the bar to stick through the end. Whats the trick to setting these, front and rear. I'm used to haveing a ball link that you can lean forward or back to change pre load.
Thanks
Toe - eyeball it
Front sway - don't stick the bar all the way to the end of the ball. About halfway in is right. You want there to be play in the bar and for it to move freely but not too much slop.