Originally posted by jag
I can adjust the droop by rotating the cam? Why does tightening the screw cause the suspension to bind? I have the aluminum sway bar mounts, if that makes any difference.
Thanks
You set your droop with the screws without the anti-roll bar connected, but then you have to re-adjust them once you re-connect the anti-roll bar with the eccentric cam to get the left and right droop equal - otherwise there would be a difference between the two sides.
Ah, yes, forgot to mention about the alu bar mounts. You need to clean up the hole where the bar mounts mount onto the suspension bar pin.
Take a 3mm drill-bit and let it run through this hole a few times - it just takes a tiny bit of material off - enough to free up the movement of the suspension arms again
Cheers, Mark.