Originally Posted by
Solara
You are running BOOST (428) program, with a 5.5T motor and using the highest timing (4 dot 27.5*) on it...? You are lucky you didn't blow up that motor....when i run mod with boost, I set the motor with the LOWEST timing as possible.
I would change the insert on your LRP to 0 dot and try again....if the GT2 work with the 2010 version 528, it will work on the 2012 version 428....
Let us know your setup on the 428....
Also, you mentioned it work on 1/4 speed....do you mean it only give you 1/4 of the throttle..? After you load the software, did you recalibrate with your radio again..? Every time you changed software, you have to recalibrate with your radio (with your ESC).
Every time i load a new software i recalibrate the speed.The timing in x20 is the lowest 4dot 27.5 the other is 30, 32.5, 35 and 37.5.
I will tell you exacly what it made me.
For the first 30 seconds the speed work in full throttle.after that when i keep the trhottle in 1/4 for 1 sec(entering a corner) and give all the thortle exiting the corner the car goes with 1/4 of thorthe.I dont have full thortle.When i leave and give again full thortle gives me 3/4.I work it like a nitro with playing all the time with trhottle to work.
I play
Drag Brake Force 15%
Low Voltage Cut-Off 3,4v/cell
"DDRS" Start Mode level 3
Maximum Reverse Force 50%
Initial Brake Force 0%
Neutral Range 6%(Narrow)
Turbo Open Time 12 deg/0.1sec
Boost Start RPM 9000rpm
Turbo Open Delay 0.2 sec
acc 750