Hi Guys: I bought a used SCTE with an RX8 and a pro 4 4000 kv motor. It runs great.
I noticed that the seller hadnt hooked up a sensor cable, so I bought two generic 6 pin cables from a LHS.
Whenever I plug in a sensor cable, the motor cogs badly and overheats in about 2 minutes. I unplug the cable, and things are fine again.
1. Is it possible that the Sensor PWB is bad?
2. What can I check to verify if its faulty?
3. Do Tekin sensor wires have a typical pinout or something special?
4. Is running sensored a big improvement over Non-Sensored?
BR Jerry (Obviously I have no Idea what im doing)