R/C Tech Forums - View Single Post - Spec-R R1
Thread: Spec-R R1
View Single Post
Old 03-07-2013, 01:10 PM
  #1097  
pata
Tech Rookie
 
Join Date: Feb 2013
Posts: 10
Default

thank you grippgoat
though of shims first but found out later it was the outer hinge ping (wheel side) that was not totally free it moved but needed little more reaming to get free also slightly sanded the plastic holder that holds the center rod stopper so it roll better yet no slide sideways.

rebuilding half car again to get everything smooth.

yet another question on sway bars. where supposed to get the bar hold into the arms tie rod, all way in, half, just so the screw holds it? does it really matter?

Last edited by pata; 03-07-2013 at 01:42 PM.
pata is offline