Originally Posted by
Jonathan Paulk
I had the same fitment problems you mentioned, until I took out all the shims. The hexes fit perfect now, no problems at all. You have to remove all the shims for the hexes to fit properly. Even though I have only one practice day and one race day on these parts, I have had no problems with the hexes rounding out.
Not sure removing the spacer I have is going to do much except allow the hex to get a little closer to the hub. The problem is the inside of the hex is rounding out causing the slop. It's only rounding out a smidge but it's enough to cause major wobble if it's not on there exactly perpendicular to the axle. And I only run mod so any little vibration is amplified!
Please keep me updated after you have a chance to run on them for a little and let me know how they are holding up.
Thanks!