Originally Posted by
nv529
I'm using the following on my conversion every part is "bolt on" no mods/dremel work needed.
Elite RC D8 motor mount With the Elite RC motor mount, make sure you use the D812 kit supplied 1mm washers placed under the diff assembly to prevent the spur gear from sticking out of the chassis bottom. See attached photo, Red ovals are the washers need, and blue lines indicates to dremel flat the side tabs on the washer to fit under the Elite RC motor mount.
RC monster D8 battery tray
HPI Vorza radio box
HPI Vorza center Diff top deck not necessary for the conversion, stock center diff top will work.
Ofna NEXX8 plastic spur gear Again, not necessary for the conversion, stock spur will work, however if you do want to run this plastic spur you'll need to dremel the slot opening on the chassis for the plastic spur gear to fit correctly and use the Vorza center diff top deck listed.
I have a quick question will the esc fit where the radio box is? if the box was not there is there enough room to fit ESC?
Thanks Paul