Originally Posted by
B00t13g
Evidently I'm not capable of figuring out how to get my trf damper mounted properly. My issue is I have the droop set where I would like it, but there's too much tension on the spring and I end up with a 5mm ride height where as the rear pod is at 4 and the front is at 4. I was using the long ball end with around 4mm of limiting mounted on the far holes of the middle shock mount. What am I doing wrong?
First you need to know what shock shaft you have build in along with the amount of spacers inside the damper (for rear droop purpose), cause the shock shaft of a touring car is about 2mm shorter then a shock shaft of the F103GT (53901)
My TRF damper is mounted just like yours and i have no problems with the spring having tension.
Hope this helps you.