Originally Posted by
Deaner
Started building the kit, and its been a pleasure to build so far except for a couple heads striping on fasteners. On the front bulk head I had two 3x10 2mm bhcs strip out on me, one in the top of the diff case and one for the shock tower. Had to use a dremel to cut a slot in the top of the head and turn them out with a screwdriver, and it was tight to get to them with the dremel. Used some replacements and noticed the heads are deeper on them then the xray screws.
I bought new bits for this build, pre tapped everything and only tighten to snug. Never had a problem stripping allen key heads before. Anyone else have this issue?
Xray seems to have gotten a bad batch of screws as this seems to be a common complain. I had to Dremel several screwsyself. Just replace them and you should have no worries