Originally Posted by
Airwave
Hi guys!
I just finish mine!
Quite complicated to assemble with only this small piece of paper... So after the first one, I look for the Vimeo page and everything was better...
By the way, I find the quality a little bit approximative, as I have defaults on the anodization... but I can live with that...
The other point bothering me is that it seems that I have a shock shorter than the others...
The shaft seems not to go as low as the others...
Is there any feedback about a similar problem?
From what can this problem come?
Thanks in advance.
1) Where'd you get that sexy purple shock stand?
2) Is it possible that you actually just got that one cap to screw on more, so the top of the shaft sticks out more? Maybe measure the length of the shock body + cap to see if that's what's going on?
I wasn't really able to get any support for my issues through the vendor in Hong Kong. He did talk to his distributor about them, but it wasn't helpful, and I didn't even get replacements for the torn O-rings inside the cap. I haven't followed up with AME directly yet, because just thinking about them makes me
.
-Mike