Originally Posted by
aarcobra
I could be a smart a$$ and say "camber, we don't need no stinkin' camber!" But, although it is more difficult, it was done "back in the day". One method is to machine/sand material from the bottom of the front end pieces to the camber angle you want. Then you can use tapered shims to fine tune. or you just make tapered shims... (When you remove material it also allows you to adjust ride height, using shims.)
I know-Too much work!
(I answered for Matt for two reasons: 1) he should be working and 2) he's so young, he might not know!!!)
if i may answer for him, youre too old too remember