Originally Posted by
92GTA
Yeah I followed my manual and it told me to put the small bearing inside the bell, the large bearing on the end of the bell with the thrust bearing on it under the screw at the end. That's where I got confused. So I guess just because it's the same clutch type means they don't all go together the same way? So by following the RRR instructions I still have the same problem I did lol.
Use a longer thrust bearing retainer!
http://www.rcmanufactory.com/prodimg/K14133-3.jpg
Like one of these. Take a measuement of your existing one's length and get one slightly longer. Alternately you could just shim out the retainer between the crank with small shims, but they are a pain and u lose them when servicing the clutch.