R/C Tech Forums - View Single Post

02-16-2013, 02:35 PM

#35

peter george

Tech Champion

iTrader: (377)

Join Date: Jan 2008

Location: queens ny

Posts: 9,808

Trader Rating: 377 (100%+)

Quote:

Originally Posted by wtcc

Thanks for the ideas, guys!

Right now there are no problems with the turnbuckle angles as you can see on the video there is no visible angle change:
http://www.youtube.com/watch?v=GEUVX...ature=youtu.be

I think the two servo idea offers a lot of potential. And as it should be no problem to do so I will sure try it sooner or later. I would need only a second servo which would be taped to the place it normally resides. The complicated thing is the servo mixing (for me) as I never did that. Do you know if a Sanwa MT4 is able to do that?

The way I had done it was without servo mixing....just a servo female type ''2 into 1'' wire so when the receiver gave the command,both servos operated. Much like a Y connection.

Reply